Defender 4K Product Manual
Table Of Contents
- 1 THANK YOU
- 2 WARRANTY INFORMATION
- 3 DISCLAIMERS
- 4 SAFETY WARNINGS
- 5 COMPLIANCE STATEMENTS
- 6 WHATS INCLUDED
- 7 GETTING STARTED
- 8 START UP
- 9 USING YOUR SYSTEM
- 10 PLAYBACK
- 11 EXPORT
- 12 VIDEO RECORD SETTINGS
- 13 CAMERA SETTINGS
- 14 CONFIGURATION
- 15 MANUAL CAMERA SETTINGS
- 16 HDD SETTINGS
- 17 SYSTEM MAINTENANCE
- 18 ANALYTICS (IP CAMERA REQUIRED)
- 19 CAMERA INSTALLATION
- 20 HARD DRIVE INSTALLATION
42
13.3 IMAGE
RIGHT CLICK MENU > DEFENDER 4K MENU > CAMERA SETTINGS
Use this section to change the image settings for each camera.
13.3.1 Image Settings
1. Use the Camera drop-down to select a camera.
2. Use the Time Segment time icon to select a time frame the settings will be applied to.
Select the Start/End Hour : Minute using the up/down arrows.
The default is set to all
day however depending on the location of the camera you may need to adjust the
settings for a specific time of day to ensure a clear image.
3. Use the Mode drop-down to select the mode that best fits the location of the camera
(example: if the camera is located under an overhang, you might want to select Dim Light).
4. Use the slide bar or up/down arrows to adjust the Image Settings. You can see the
results in the preview window.
5. Click Apply to save these settings or Default to return to the original settings.
6. Use the Copy function to apply these settings to other cameras. The image settings
requirements may not be the same for all camera locations.
CONTENTS