Defender 4K Product Manual
Table Of Contents
- 1 THANK YOU
- 2 WARRANTY INFORMATION
- 3 DISCLAIMERS
- 4 SAFETY WARNINGS
- 5 COMPLIANCE STATEMENTS
- 6 WHATS INCLUDED
- 7 GETTING STARTED
- 8 START UP
- 9 USING YOUR SYSTEM
- 10 PLAYBACK
- 11 EXPORT
- 12 VIDEO RECORD SETTINGS
- 13 CAMERA SETTINGS
- 14 CONFIGURATION
- 15 MANUAL CAMERA SETTINGS
- 16 HDD SETTINGS
- 17 SYSTEM MAINTENANCE
- 18 ANALYTICS (IP CAMERA REQUIRED)
- 19 CAMERA INSTALLATION
- 20 HARD DRIVE INSTALLATION
44
13.4 MOTION
RIGHT CLICK MENU > DEFENDER 4K MENU > CAMERA SETTINGS
This section allows you to set up area to exclude from motion detection. This can be helpful to block out
areas that may trigger unnecessary recording (example: background traffic areas).
1. Use the Camera drop-down to select a camera.
2. Click the Enable Motion Detection checkbox to allow for motion only recording.
3. Click Setting:
• Pre-record: The number of seconds the DVR will record before the motion event occurs
• Post-record: The number of seconds the DVR will record after the motion event occurs
4. Use the slide bar to set the Sensitivity for how much motion needs to be detected to trigger
recording.
The greater the sensitivity (closer to the right side) the more sensitive to motion the
system will be.
5. Click and drag the mouse within the preview window to set the areas where motion will not be
detected.
• Red grid areas indicate motion will trigger recording
• Clear areas indicate motion detected will not trigger recording
6. Click Full-screen to view the preview window in full screen to select motion areas.
7. Click Clear to remove all motion areas.
8. Click Apply to save these settings.
9. Use the Copy function to apply these settings to other cameras The motion detect areas may
not be the same for all cameras.
CONTENTS