Instruction manual

PX301
No Picture/Signal • Makesurealltheconnectionsaresecureandproperlyconnected
• Makesureyourreceiverispluggedintoapowersourcefromthe9VDCinputthe
back
• Makesurethereisnothingobstructingtheviewofthecamera
• Tryre-pairingthecameraandmonitor
Picture too Bright
or Dark
• Thenightvisioncomesonautomaticallywhenthelightlevelsdrop;trythecamera
in a pitch black setting. The area that the camera is in may get too much light to
activate the sensor
• Try adjusting the brightness settings on your receiver
No Audio • Makesurenothingisinterferingwiththemicrophoneonthecamera(within6ft)
• Makesurewhateveryouaretryingtoheariscloseenoughtothemicrophoneonthe
camera
• Disconnectandreconnectthewiresfromthecameraandthereceivertomakesure
they are secure
• Tryre-pairingthecameraandreceiver
• Tryadjustingthevolumeonthemonitorthatthereceiverispluggedinto
• Ensure that the camera volume is turned up using the remote
• Ensure that the AV cord is connected to the proper connections on the receiver and
on the monitor that the receiver is connected to
Buttons are not
working
• The buttons do not work in quad screen mode, ensure you are viewing full screen
• Make sure the button lock function (on the front of the receiver) is not switched on
Devices are not
pairing
• Ensure that the camera and receiver are within 100ft of each other
• Try moving the devices closer together, sometimes walls/other obstructions can get
in the way of the camera and receiver’s signal
• Ensure that both devices are connected to a proper power source
Night Vision not
Working
• Thenightvisioncomesonautomaticallywhenthelightlevelsdrop;trythecamera
in a pitch black setting. The area that the camera is in may get too much light to
activate the sensor
I am getting a “No
Signal” message
• Tryre-pairingthecameraandreceiver
• Makesurethereisnothingobstructingtheviewofthecamera
• Makesurethecameraandreceiverarewithin100ftfromoneanother
Footage not
recording
• Adjustwhatrecordingsettingyouaresetto
• MakesureSDcardiscompletelyinthereceiver
• MakesureSDcardisnotfullandthatoverwritefunctionisturnedon
• MakesureSDcardisnotlockedbyadjustingthetabonthesideofthecard
Remote not
working
• Ensure that the remote control has batteries inserted into it and that those batteries
are not dead
• Try plugging the IR sensor in
• Try using the remote control closer to the receiver
TROUBLESHOOTING
8