Specifications

MAINTENANCE I 10 I
L7Xp :.
..':? Diesel engine
TOP
- UP BRAKE VACUUM PUMP OIL - 2.25 litre
TOP
- UP CARBURETTER PISTON DAMPER - V8
only
'. .. .
..-I 1.1,
1. Slacken the drive belt, and the pump pivot bolts 1. Unscrew the cap on top of both suction chambers
and withdraw the damper.
2. Move the pump to an upright position and 2. Top-up the reservoir with engine oil to within
12 mm (0.5 in) from the top of the hollow piston
rod. Refit
the damper and secure the cap.
and nuts and slip the belt from the pulley.
temporarily tighten the nuts and bolts
to maintain
this position.
3. Turn the pump pulley so that the indicating marks
on the pulley hub and pump body line up.
- . '..
,.
. ..
..
I, :, :'
.. .
.~ ...
.._ ,'*
..
. .. .. .
3
4. Remove the oil level plug at the rear of the pump
and
if necessary inject a recommended SAE
15W-50 oil up to the level of the hole.
5. Refit the level plug, and fit and tension the drive
belt.
ST
4
1008M
/4
REAR SUSPENSION BALL JOINT
1. Apply a grease gun to the nipple using a
recommended grease.
RENEW LT85 MAIN GEARBOX OIL
Drain and refill monthly when operating under severe
wading conditions.
To change the
gcarbox oil proceed as follows:
1. Immediately after a run when the oil is warm, drain
off the oil into a container by removing the drain
plug and washer from the bottom of the gearbox
casing.
2. Remove the oil filter.
3. Wash the filter in clean fuel; allow to dry and
replace.
4. Clean and refit drain plug and washer and refill
gearbox through the
oil level/filler plug, with the
correct grade of oil, to the bottom
of the oil
1eveYfiller hole. For capacity see Data Section.
7