Full Product Manual

ManualsBrandsDefiant ManualsElectricalPlug-In Dual-Outlet Heavy-Duty Timer

Risk of electric shock

• Plug directly into an

electrical outlet

• Do not use in wet locations

• Use indoors only

• Unplug timer before

cleaning

• Keep children away

WARNING

Risk of fire

• Do not use to control

appliances that contain

heating elements (cooking

appliances, heaters, irons, etc.)

• Do not exceed electrical

ratings

INSTRUCTIONS:

1. Locate the segments around the outer edge of the timer’s dial. These segments, each representing 30 minutes, can be

pushed down from the edge of the dial (try using the tip of a pen or pencil). Conversely, segments that have been pushed

down can be easily pulled back up by hand. Be sure all segments are pulled up before programming.

Select a time period (or periods) you want the lamp turned on, then push down ALL the segments that fall on or within that

time period. For example, to have the timer turn a lamp on at 10PM and off at 2AM, push down the segments representing

10PM and 2AM, and ALL the segments in between (See Figure 1). You may need to turn the dial clockwise to access the

desired segments.

2. Rotate the timer’s dial clockwise until the pointer on the face of the dial points to the current time of day. Note: Nighttime

hours (from 6:30PM to 6:30AM) are highlighted with a grey background.

3. Set master switch to the TIMER ON position. (See Figure 2)

4. Plug the timer into an electrical outlet convenient to the lamp to be controlled.

5. Plug the lamp into either outlet on the sides of the timer. Turn the lamp’s switch on for automatic control. The timer will not

turn the lamp on if the lamp’s switch is off. The lamp will now turn on and off at the times you have set. The setting on the

timer will be used for both outlets simultaneous.

NOTE: To override the timer and use your lamp normally, set the master switch to the OUTLET ON position. See Figure 2. This

will deactivate the timer’s control of the lamp, but the timer’s dial will still show the current time of day. To reactivate the

timer’s control of the lamp, turn the lamp’s switch on and set the timer’s master switch to TIMER ON. In case of power failure,

reset the time of day as explained in step 2.

DO NOT PLUG IN MORE THAN THE RATED LOAD (SEE RATINGS). To find total watts being used: If watts are not marked on the

appliance, multiply ampere rating (on nameplate) by 125 volts to determine equivalent watts. For lamps with multiple bulbs,

sum wattage on bulbs.

This is a GROUNDED device. It has a grounded plug and two grounded outlets.

Figure 1

Timer is set to turn on at 10:00PM and off at 2:00AM.

Timer shows 9:30PM time of day.

Figure 2

Master Switch - When pushed to “timer on” timer controls

appliance. When pushed to “outlet on” the timer acts like an

outlet. Timer outlet is always supplying power.

15075

Version 3

10.18.2010

www.jascoproducts.com

Insert

Summary of content (1 pages)

PAGE 1
Insert INSTRUCTIONS: 1. Locate the segments around the outer edge of the timer’s dial. These segments, each representing 30 minutes, can be pushed down from the edge of the dial (try using the tip of a pen or pencil). Conversely, segments that have been pushed down can be easily pulled back up by hand. Be sure all segments are pulled up before programming. Select a time period (or periods) you want the lamp turned on, then push down ALL the segments that fall on or within that time period.