Instructions / Assembly

6
Installation
1
Installing the Mounting
Bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light xture.
Ƒ Remove the existing light xture.
Ƒ Install the mounting bracket (HH) with the
stamped word “FRONT” facing away from the
junction box. Use the mounting bracket screws
(DD, EE, or FF) that best t the junction box.
NOTE: Firmly pull on the mounting bracket to verify it is
securely mounted to the junction box. If necessary, use the
screws that were removed from the existing light xture.
FRON
T
FRONT
2
Hanging the Light Fixture
Temporarily
Ƒ Insert the small end of the plastic hanger (II)
through the center hole of the canopy (B) and
the gasket (GG).
Ƒ Insert the small end of the plastic hanger (II)
into one of the two small, slotted holes on the
mounting bracket (HH).
Ƒ Route the light xture wires through the large
holes in the gasket (GG).
FRON
T
FR
O
NT
3
Wiring the Light Fixture
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
Ƒ Connect the light xture wires to the junction
box wires with wire connectors (AA):
Ƒ White to white
Ƒ Black to black
Ƒ Bare or green ground wire to house ground
4
Mounting the Light Fixture
Ƒ Remove the plastic hanger (II).
Ƒ Insert the small end of the mounting bolt (CC)
through the center hole of the canopy (B) and
the gasket (GG).
Ƒ Align the mounting bolt (CC) with the center
hole in the mounting bracket (HH) and tighten
securely. Do not overtighten.
Ƒ Push the rubber plug (BB) rmly into the
mounting bolt hole on the canopy (B).
NOTE: Make sure all the wires are inside the junction box
before attaching the canopy (B) to the junction box.
FRONT
DD, EE, or FF
HH
HH
II
GG
B
II
HH
GG
CC BB
B
AA
AA