Lacey Act Declaration Form

2
Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Precautions ............................................2
Warranty ...................................................2
2-Year Warranty .....................................2
Specifications ...........................................3
Pre-Installation .........................................3
Planning Installation ..............................3
Tools Required .......................................3
Hardware Included .................................4
Package Contents ..................................5
Mounting Locations ...............................5
Installation ................................................6
Operation...................................................7
Care and Cleaning ..................................10
Troubleshooting ......................................10
Safety Information
PRECAUTIONS
□ Please read and understand this entire manual
before attempting to assemble, install, or operate
this light xture.
□ This light xture requires 120-volts AC.
□ Some codes require installation by a qualied
electrician.
□ This light xture must be properly grounded.
□ This light xture is intended for use with the
enclosed gasket and with a junction box marked for
use in wet locations.
□ This light xture should be installed outdoors to a
wall or eave.
□ The light xture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light xture
is mounted higher than recommended, aiming the
sensor down will reduce the coverage area.
□ Do not leave the “ON-TIME” switch in the “TEST”
position. The frequent ON/OFF cycling of the light
xture will reduce the life of the bulb.
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light xture.
WARNING: Risk of re. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of re. Keep the bulbs at least 2in.
(51mm) from combustible materials.
CAUTION: Keep the motion sensor at least 1 in. (25 mm)
away from the bulbs.
CAUTION: Keep the bulb holders 30° below horizontal to
avoid water damage and electrical shock.
CAUTION: To avoid water damage and the risk of
electrical shock, the motion sensor controls must be facing
the ground when the installation is complete.
CAUTION: Burn hazard. Allow the light xture and the
bulb to cool before touching.
CAUTION: Do not cut any wires with factory installed
wire connectors or remove the wire connectors.
NOTICE: Do not connect this light xture to a dimmer switch or
timer.
Warranty
2-YEAR LIMITED WARRANTY
WHAT IS COVERED
This product is guaranteed to be free of factory defective parts and workmanship for a period of 2 years from date
of purchase. Purchase receipt is required for all warranty claims.
WHAT IS NOT COVERED
This guarantee does not include repair service, adjustment and calibration due to misuse, abuse or negligence, or
LEDs. Unauthorized service or modication of the product or of any furnished component will void this warranty in
its entirety. This warranty does not include reimbursement for inconvenience, installation, setup time, loss of use,
unauthorized service, or return shipping charges. This warranty is not extended to other equipment and components
that a customer uses in conjunction with this product.
Contact the Customer Service Team at 1-866-308-3976 or visit www.homedepot.com