Lacey Act Declaration Form

10
Care and Cleaning
□ To prolong the original appearance, clean with clear water and a soft, damp cloth only.
□ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
□ Do not spray with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on. □ The light switch is turned off. □ Turn the light switch on.
□ The bulb is loose or burned out. □ Check the bulb and replace
if burned out.
□ The fuse is blown or the circuit breaker
is turned off.
□ Replace the fuse or turn the
circuit breaker on.
□ Daylight turn-off (photocell) is in effect. □ Recheck after dark.
□ The circuit wiring is incorrect, if this is
a new installation.
□ Verify the wiring is correct.
□ The motion sensor is aimed in the
wrong direction.
□ Re-aim the motion sensor
to cover the desired area.
□ The outside air temperature is close to
the same as a person’s body heat.
□ Increase the “RANGE”
setting.
The light comes on during the
day.
□ The motion sensor may be installed in a
relatively dark location.
□ The light xture is operat-
ing normally under these
circumstances.
□ The “ON-TIME” switch is in the “TEST”
position.
□ Set the “ON-TIME” switch
to the 1, 5, or 20 minute
setting.
The light comes on for no
apparent reason.
□ The motion sensor may be sensing
small animals or automobile trafc.
□ Re-aim the motion sensor.
□ The “RANGE” dial is set too high. □ Decrease the “RANGE”
setting.
□ The “DUALBRITE” switch is in the 3
hour, 6 hour, or dusk-to-dawn setting.
□ The light xture is operat-
ing normally under these
circumstances.
□ The outside temperature is much
warmer or cooler than a person’s body
heat (summer or winter).
□ Decrease the “RANGE”
setting.
□ The light xture is wired through a
dimmer or timer.
□ Do not use a dimmer or
timer to control the light
xture. Replace the dimmer
or timer with a standard on/
off wall switch.
The lights turn off too late in
Dusk-to-Dawn setting.
The light xture may be installed in a
relatively dark location.
Relocate the light xture or use
the 3 hour or 6 hour setting.