Lacey Act Declaration Form
7 HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
Installation (continued)
5
Caulking Around the Light
Fixture
□ Caulk around the canopy (B) and mounting
surface with silicone sealant (not included).
6
Installing the Shells and Bulbs
□ Align the three slots on the shell (D) with the
three nibs on the bulb holder (A).
□ Insert the shell (D) into the bulb holder (A) and
twist clockwise to lock.
□ Repeat for the other shell (D).
□ Install bulbs (not included) into both bulb
holders (A).
Operation
1
Adjusting the Bulb Holders
WARNING: Risk of re. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of re. Keep the bulbs at least 2in.
(51mm) from combustible materials.
CAUTION: Keep the sensor at least 1 in. (25 mm) away
from the bulbs.
CAUTION: Keep bulb holders 30° below horizontal to
avoid water damage and electrical shock.
□ Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□ Loosen the lock nut (1) and thumb screw (2) to
adjust the bulb holders (A) for the desired light
coverage.
□ Tighten the lock nut (1) and thumb screw (2).
NOTE: Do not rotate the bulb holders more than 180°
from the factory setting.
2
Rotating Sensor Controls
Downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
□ Rotate the motion sensor (C) so the controls
face toward the ground.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
B
A
1
2
D
D
AA
C