Full Product Manual

10
Operation (continued)
3
Testing the light
NOTE: It is recommended that the light be tested before
being placed in regular operation.
Remember to set the switch from TEST to MOTION after
testing the light.
NOTE: Testing the unit indoors or lower than 7 ft. from
the ground may not enable the light to work optimally
when mounted into its nal outdoor position.
NOTE: With the Power button (D) in the OFF position,
allow the unit to charge in direct sunlight for at least 6
hours before testing, or placing into normal operation.
Before placing the light in normal operation (Motion mode), it is
best to test the light LEDs and motion sensor. Here is the process
or doing so:
□ Activate the light by pressing the Power button (D) to the
ON position.
□ Switch the Motion/Test switch to ‘Test’. The light will turn
ON, and stay on continuously for 1 minute. Use this time to
adjust the LED light heads to where you would like them to
shine when motion is detected.
□ After the rst minute, the light will turn OFF, but will
activate for 5 seconds every time motion is detected. Use
this time to adjust the motion sensor (C) to where you want
the light to detect motion and activate. While the switch
is in ‘Test’ mode, the light will continue to activate in 5
second intervals.
□ When nished with these adjustments, switch back to
‘Motion’, and the light will go into normal operation.
Depending on your LUX setting and time of day, the light
may turn OFF until it’s dark enough to activate.
D
B
C
4
Reading the indicator light
□ The indicator light is located below the motion sensor (C),
and shows the basic status of the light.
□ If the indicator light ickers RED, the sensor is detecting
motion. This is an indication that the motion sensor is
working, even if the LED light heads are not activating.
□ If the indicator light is GREEN, the batteries are charging.
This is an indication that the batteries are not depleted,
and the transfer of solar energy to the rechargeable
batteries is working.
C