Full Product Manual

12
Maintenance
When the pre-installed, rechargeable Nickel-metal Hydride batteries have reached the end of their useful life, they can be easily replaced.
Disconnect the light from the solar panel, and unmount from its position, placing the light on a sturdy surface. Unscrew and remove the
back panel to access the batteries. Remove the batteries from the cradle, and disconnect the plug that attaches it to the light circuit board.
Connect the new batteries at the plug, and place the batteries back in position. Replace the rear cover, screwing it securely into position.
Remount the light, connect the solar panel, and follow the installation instructions. Please properly dispose of the depleted Nickel-metal
Hydride batteries.
Care and Cleaning
□ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
□ Periodically clean the solar panel with a soft cloth and warm water. Do not hose spray. Keep the panel clear of snow and leaves. Make
sure trees and other objects do not block sunlight from the panel.
□ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature deterioration of the nish. This is not
a defect in the nish and will not be covered by the warranty.
□ Do not spray the light xture with a hose or power washer.
□ If not to be used for several weeks, turn the unit OFF. Store it with the panel connected and where the panel can gather sunlight.