Full Product Manual

13 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Troubleshooting
Problem Possible Cause Solution
The light will not turn ON. The power button is OFF. Turn on the light.
The battery has run down. Recharge the battery in the sunlight.
The extension cord between the solar
panel and light xture is longer than 60 ft.
Connect to a shorter extension cord, or reposition the
solar panel closer to light xture.
The battery is dead. Replace with new rechargeable Nickel-metal Hydride
batteries.
The solar panel is not positioned correctly. Adjust the panel angle to face southward for sufcient
and direct sunlight.
The solar panel location is not optimal. The solar panel must face South and have clear exposure
to the sun. If the panel cord is not long enough, an
extension is available at Homedepot.com.
The motion sensor position is not optimal. Adjust the SENS dial between "Low-Medium-High"
accordingly.
Other surrounding light sources are
triggering the photocell.
Adjust the LUX setting to compensate for other light
sources such as street lamps and house lights.
Surrounding air temperature is greater
than 122°F (50°C) or less than -4°F
(-20°C).
The light will operate normally within the specied
temperature range.
The green indicator light
continues to ash but the light
does not turn ON.
There is a program error. Disconnect the battery and reconnect to perform a reset.
The light appears dimmer than
normal.
The rechargeable Nickel-metal Hydride
batteries are low and the unit switches to
ECO mode automatically.
□ When the battery is charged back to 3.7V, the light
will quit ECO mode and return to normal brightness.
□ Adjust the TIME dial to a smaller amount of time to
help save battery.
The light turns ON during the day. The light is mounted in a dark location. □ Adjust the LUX dial towards "L".
□ If still malfunctioning, relocate the light to a location
away from shadows.
The light appears to “strobe” or
ash.
The battery is low. Turn OFF the light and charge the battery by direct
sunlight.
Check if any surrounding light source
illuminates or reects ambient light
towards the motion sensor.
Remove surrounding light sources that affect the motion
sensor, or relocate the light to ensure no light reects
onto the motion sensor.
There is a program error. Turn OFF the light for 10 seconds. Turn ON thereafter.