Full Product Manual

Installation (continued)

Mounting the solar panel

RECOMMENDED: Caulk around the base and on top of

the screw heads after installation

Place the solar base (F) against the mounting surface and mark the

mounting holes.

□ If mounting to a wooden surface, drill four 3/32 in. holes

into the mounting surface. Install the four mounting screws

(CC) through the solar panel base (F) and into the mounting

surface.

□ If mounting to wall board or brick, drill four 7/32 in. holes

into the mounting surface. Insert the wall anchors (DD) and

attach the solar panel base (F) using the four mounting

screws (CC).

□ Once the solar panel base (F) has been installed, position

the solor panel (E) above it, adjusting the direction and

angle of the panel to its desired position to receive optimal

sunlight.

□ Place the panel (E) into the base (F) and use the base

screw (BB) to secure the panel (E) in place on the base (F).

Adjusting the solar panel

IMPORTANT: The solar panel (E) must receive as much

direct sunlight over the course of the day as possible. Keep

in mind that shadows may block the sunlight from reaching

the solar panel (E) during the day.

□ Rotate the solar panel (E) to the desired angle.

Connecting the solar panel to the

light xture

□ Carefully connect the solar panel (E) cable to the light

xture (B). Screw the caps on the plugs rmly.

□ Wrap any excess solar panel cable around the base (F)

located on the rear of the solar panel (E). Leave enough

loose cable to form a drip loop.

IMPORTANT: Push the switch to the OFF position and

allow the battery to charge with 2 to 3 days of full sunshine

before testing.