FAQ

Question
Answer
What bulbs are compatible?
□ Compatible with all of the following bulb types: PAR38 halogen, PAR38
incandescent, PAR38 dimmable LED (EnergyStar listed, UL listed, outdoor
rated-wet rated), and PAR38 dimmable CFL (outdoor rated-wet rated).
How to adjust for sensitivity vs area
of coverage?
□ On the bottom of the sensor head there is a rotating dial that goes from Min
to Max. When this dial is closer to Min the sensitivity is lower. When the dial
is closer to Max the sensitivity is higher. This is often confused with how far
the sensor detects movement but that is not the case. The detection area is
determined by the position of the sensor head or how it is pointed. When
the sensor is pointing straight out and the controls are level with the ground
it will be able to detect to its maximum potential (refer to the manual for
each fixture’s max distance). If the detection area needs to be decreased
the sensor should be tilt down.
What is DualBrite®?
□ DualBrite® is a patented, optional feature that allows the light to provide
low-level, accent lighting at approximately 50% of the watts of the bulb until
motion is detected. When motion is detected, the light illuminates to full
brightness until the On-Time setting expires (1, 5 or 10/20 minutes
depending on model) then it returns to the accent level. The DualBrite®
feature can be set to various time intervals beginning at dusk and
continuing for 3 hours, 6 hours, or until dawn. The DualBrite® feature can
also be turned off and the light will function as a motion activated light only.
Note: The DualBrite® feature and switch DO NOT control the photocell. The
photocell is controlled by the On-Time switch.
Why does my light not detect my
vehicle when I pull into my
driveway at night?
□ A vehicle with its headlights ON may trigger the photocell preventing the
light from turning on because it appears to be daylight.
□ Many vehicles these days are so well insulated that the heat signature of
the vehicle may not be enough to trigger the motion sensor.
Can I use the motion sensor to
control other devices such as
buzzers or sirens?
□ No, our motion sensors are designed to control lighting only.
Does my light need to be earth
grounded?
□ Yes, if your light is equipped with a grounding device (a green wire, bare
copper wire, or grounding screw) it must be used to properly connect your
light.
Does my light need to be mounted
to a junction box?
□ Yes, a junction box is required to ensure your light is properly installed and
the wiring must meet wiring code.
Is it necessary to have a light
switch in the circuit for my motion
sensing light to operate properly?
□ A light switch is not required. However, without a light switch in the circuit
your motion sensing light(s) will operate in the AUTO MODE only. The
motion sensing light cannot be switched to the MANUAL MODE.
Why does my light have some
wires connected and their wire nuts
crimped?
□ The lights and the motion sensor are pre-wired leaving only the wires
needed for connection to the home accessible. Look for one BLACK wire,
one WHITE wire and a Ground wire or screw to connect to the power
source. The crimped cap on the RED power lead should be left as it is
connected at the factory.
Frequently Asked Questions: PAR Motion Security Lights