Instructions / Assembly

9 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Operation (continued)
7
Completing motion sensor
setup
Ƒ After all motion sensor (C) adjustments are
complete, rotate the motion sensor (C) so the
controls are facing the rear of the xture (B)
and the two dots are in alignment.
Care and Cleaning
Ƒ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
Ƒ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
Ƒ Do not spray the light xture with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on. Ƒ The light switch is turned off. Ƒ Turn the light switch on.
Ƒ The fuse is blown or the circuit breaker
is turned off.
Ƒ Replace the fuse or turn the
circuit breaker on.
Ƒ Daylight turn-off (photocell) is in effect. Ƒ Recheck after dark or turn
the “LUX” dial toward the
“ + ” position.
Ƒ The circuit wiring is incorrect (if this is
a new installation).
Ƒ Verify the wiring is correct.
Ƒ The outside air temperature is close to
the same as a person’s body heat.
Ƒ Increase the “SENS”
setting.
The light comes on during the
day.
Ƒ The motion sensor may be installed in a
relatively dark location.
Ƒ The light xture is operating
normally under these
circumstances.
Ƒ The “LUX” control is turned to the “ +”
position.
Ƒ Turn the “LUX” dial toward
the “ – ” position.
B
C