Instructions / Assembly
11 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Troubleshooting (continued)
Problem Possible Cause Solution
The lights stay on continuously. □ The motion sensor may be picking up a
heat source, such as an air vent, dryer
vent, or brightly painted, heat-reective
surface.
□ Decrease the “SENS”
setting or reposition the
motion sensor.
□ The motion sensor is in motion off
mode (the red LED behind the motion
sensor lens is not blinking).
□ Switch the motion sensor to
motion on. See Switching
motion detection off and on
on page 9.
□ The light xture is wired through a
dimmer or timer.
□ Do not use a dimmer or
timer to control the light
xture. Replace the dimmer
or timer with a standard on/
off wall switch.
□ The light xture is on the same circuit
as a motor, transformer, or uorescent
bulb.
□ Install the light xture on
a circuit without motors,
transformers, or uorescent
bulbs.
The lights ash on and off. □ Heat or light from the bulbs may be
turning the motion sensor on and off.
□ Reposition the lamp heads
away from the motion
sensor.
□ Heat is being reected from other
objects and may be turning the motion
sensor on and off.
□ Decrease the “SENS”
setting or reposition the
motion sensor.
□ The motion sensor is in “TEST” mode
and warming up.
□ While in “TEST” mode, the
light only stays on for 8
seconds. Set the “Test /
Timer” control to a timed
setting.