Instructions / Assembly

5 HOMEDEPOT.COM

Please contact 1-866-308-3976 for further assistance.

Installation

Determining the mounting

location

NOTE: The light xture should be mounted approximately

8 ft. (2.4 m) above the ground. If the light xture is

mounted higher than recommended, aiming the sensor

down will reduce the coverage area.

□ Determine the mounting location – wall or eave

mount.

□ Position the lamp heads (A) in the general

direction of the desired light coverage.

Wall Mount

Eave Mount

Removing the mounting plate

NOTE: This xture comes with a mounting plate (D). It is

pre-assembled on the light xture (B) for shipping.

NOTE: The large mounting bolt (EE) is pre-installed in

the light xture (B). Do not attempt to remove the large

mounting bolt (EE).

□ Unscrew the large mounting bolt (EE) connecting

the light xture (B) to the mounting plate (D) and

remove the mounting plate (D).

Installing the mounting bracket

WARNING: Turn the power off at the circuit breaker or

fuse. Place tape over the circuit breaker switch and verify

power is off at the light xture.

NOTE: Four mounting bracket screws of various sizes are

included. The installation will only require two. Discard the

unused mounting bracket screws after installation.

□ Remove the existing light xture.

□ Install the mounting bracket (FF) with the

stamped word “FRONT” facing away from

the junction box. Use the mounting bracket

screws(BB or CC) that best t the junction

box. If necessary, use the screws that were

removed from the existing light xture.

□ Firmly pull on the mounting bracket (FF) to

verify it is securely mounted to the junction

box.

FRON T

FRONT

BB or CC