Instructions / Assembly

10
Troubleshooting
Problem Possible Cause Solution
The light will not come on. □ Daylight turn-off (photocell) is in effect.
□ The motion sensor is out of coverage
area.
□ Batteries are dead.
□ Batteries may be incorrectly installed.
□ Set the DUSK LEARN at
desired lux level.
□ Reposition the unit within
your desired detecting range.
□ Recheck with new batteries.
□ Recheck and make sure
batteries are installed
with the correct polarity
(+ & -), as shown in the
battery compartment.
The light comes on during
the day.
□ The motion sensor may be installed in a
relatively dark location.
□ DUSK LEARN was set in daylight
conditions.
□ The light fixture is operating
normally under these
circumstances.
□ Reset the DUSK LEARN
setting by pushing once at
the desired level of darkness,
or return to the factory
setting by pushing the DUSK
LEARN button twice within 2
seconds.
The light comes on for no
apparent reason.
□ The motion sensor may be sensing
small animals or automobile traffic, or
other heat sources.
□ Strong wind may activate the sensor.
□ Re-aim the motion sensor.
□ The light fixture is operating
normally under these
circumstances.
The lights stay on
continuously.
□ Another regular light is positioned too
close to the motion sensor or pointed
at nearby objects that cause heat to
trigger the motion sensor.
□ The motion sensor may be picking up
a heat source like an air vent, dryer
vent, or brightly painted, heat-reflective
surface.
□ Reposition the motion sensor
away from the light or nearby
objects.
□ Same as above.