Instructions / Assembly

HOMEDEPOT.COM

Please contact 1-866-308-3976 for further assistance.

□ If needed, gently grasp the lamp head (A), it can be

tilted down by 40°and upward by 65°. It also can

be panned left 40° and panned right 40°.

□ Hinge (4) can pan the lights in and out.

Hinge (5) can tilt the lamps up and down.

Operation

Adjusting the Lamp Head

Installation (continued)

□ Place the mounting plate (C) against the ceiling.

Mark the hole locations.

□ If mounting to a wooden surface like a deck, you

can install the mounting screws (AA) through

the mounting plate (C) and into the wood with a

screwdriver, or with a drill and bit driver.

You can also drill two pilot holes into the wood

mounting surface with a 1/8 inch drill bit and

then install the screws.

□ If mounting to wall board or brick, drill two pilot

holes into the mounting surface, using a 7/32

inch drill bit.

Insert the wall pegs (BB) and attach the mounting

plate (C) using the two mounting screws (AA)

with a very long Phillips screwdriver.

Installing the Mounting Plate

B. Eave or Ceiling Mount

Mounting the Light Fixture

□ Attach the light fixture (B) to the mounting

plate (C). Support the back-plate from behind

with one hand and push the light onto the

back-plate with the other hand.

□ Press the unit on the bottom to the mounting

plate (C). You should hear a “Click” sound.

This indicates that the device (B) is securely

attached to the mounting plate.