Installation Guide

7
Operation
1
Adjusting the lamp heads
WARNING:
□ Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□ If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
2
Setting the sensor for testing
NOTE: When the “Test / Timer” control is set to the “Test”
night. The light will stay on for 5~8 seconds after all motion
is stopped.
□ Turn the “TIMER MINUTES” control to the “Test”
position. And the indicator will ash 6 times.
□ Turn the “SENSITIVITY” control to the position
you want.
NOTE: The motion sensor will need to completely warm
up (30 seconds) before beginning the setup process.
3
Adjusting the motion sensor
detection zone
□ Perform a “walk test”: walk in an arc across
the front of the motion sensor (C).
□ Watch the light. The light will come on and the
detected.
□ Stop, wait for the light to turn off, and then
begin walking again.
□ Continue this process until the detection zone
has been established.
□ If needed, gently grasp the motion sensor (C)
and move it from side to side or up and down
to adjust the detection zone.
□ To ensure the motion sensor work properly,
please keep the marking "THIS SIDE UP" on
the motion sensor up.
□ It's recommended to keep the motion sensor
tilt angle within 40° under daily usage.
C
HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
40°