Installation Guide

8
Operation (continued)
4
Adjusting the SENSITIVITY
control
□ To increase the sensitivity, turn the “SENSITIVITY”
control counterclockwise.
□ To decrease the sensitivity, turn the “SENSITIVITY”
control clockwise.
NOTE: The motion sensor (C) is more sensitive to motion
moving across the front of the sensor. The motion sensor
(C) is less sensitive to motion moving directly toward the
front of the sensor.
NOTE: The higher the “SENSITIVITY” setting, the greater
the possibility of false triggering. To reduce false
triggering, please choose the sensitivity you need.
5
Adjusting the TIMER control
NOTE: The "TIMER MINUTES" control determines the
amount of time the light will stay on full bright after all
motion has stopped. And if you turn to "D2D" position, it will
be a dusk to dawn (night time) light.
□ Auto mode: After all adjustments are complete,
turn the “TIMER MINUTES” control clockwise and
select a time 1/5/10 minutes. The light will only
work at night after a time has been selected.
□
D2D mode: If you turn the "TIMER MINUTES" to "D2D"
position, it will be a dusk to dawn (night time) light.
The motion detection will be off, and the light will
be always on at night, will turn off in the day time.
□ Manual Override mode: When the light is on and
setting the " TIMERS MINUTES" at 1'/5'/10'
position, if you quickly switch off and then on
within 3 seconds, the light will enter the "Manual
Override" mode. In this mode, the light will keep
on around 5.5 hours and then return to "Auto"
mode and work according to your setting(1/5/10
minutes). If you don't want keep "Manual Override"
mode, switching off and on within 3 seconds to
change it back to " Auto" mode. Or you can switch
off for more than 5 seconds before switching on,
the light will restart.