Use and Care Manual

7 HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
1
Testing the motion sensor
NOTE: Make sure you allow fixture to receive four
full days of sunlight while in OFF mode to fully charge
the battery.
NOTE: Fixture has a warm up period of about one minute.
Light will turn on during this period. Once the light turns
off, you are ready to test.
□ Move slide switch on bottom of the sensor to
“TEST”.
□ Aim sensor toward the general direction in
which motion will occur. Always position the
sensor head with control switches facing
toward the ground.
□ Walk across the detection zone at the
farthest distance you wish your detector
to detect motion.
□ For more range, aim sensor slightly upward.
For less range, aim sensor slightly downward.
Light will turn off 4 seconds after motion
stops. Allow 5 seconds after light turns off
before your next test.
NOTE: Allow 5 seconds after light turns off before your
next test.
Bottom of sensor
2
Setting the ON time
□ Move slide switch on bottom of sensor to
“1 min.” or “3 min.” Light will turn ON at night
when motion is detected and turn OFF at the
selected time interval after motion stops.
Operation
A
Bottom of sensor
A