User Manual

2322
GO SWISSDRIVE
The remaining range is indicated with a three-digit value in kilometres or miles. In
addition, the remaining range is visualised with an analogous circular instrument (1).
The algorithm for the calculation of the remaining range not only considers the total
distance ridden with the pedelec/e-bike (total data), but also the last kilometres. With
an increasing total distance the algorithm therefore adapts more and more to your ri-
ding behaviour and hereby allows forecasts for the remaining range to become more
and more precise.
A
Keep in mind that the indicated remaining range is only an approxi-
mate forecast. Due to the route prole, the selected assistance level
and many other factors there may be deviations between the indicated
value and the actual remaining range.
The lower section of the main menu (2) can be congured according to your own wi-
shes by selecting up to two parameters from the current tour data which will be shown
on the display. You can select between the following indications:
- the distance covered,
- the power consumption since the beginning of the tour,
- the mean speed,
- the maximum speed and
- the actual ride time.
The conguration is made in the settings. More information in this regard is given in
the chapter “Conguration and settings”.
 7. OVERVIEW TOUR DATA
The second riding menu gives you a compact overview about your current tour (3).
There you will nd information
- on the distance covered (3a),
- on the power consumption since the beginning of the tour (3b),
- on the mean speed (3c),
- on the maximum speed (3d) and
- on the actual ride time (3e).
You can determine the start point of a tour on your own. In this regard the Evo control
unit offers you three different options: When the tour menu is indicated, you can reset
the tour data whenever you want by pressing the Conrm key long and then start a
new tour (4).
Furthermore, you can reset the tour manually in the settings or determine that the
tour data are automatically reset after every stop longer than four hours so that a new
tour is started when you switch on the display again. More information in this regard
is given in the chapter “Conguration and settings”.
I
The tour data are only indicated correctly if the circumference of tyre of
your pedelec/e-bike is set correctly. You can adjust the circumference
of tyre in the settings (see chapter “Congurations and settings”).
42
3
a
b
c
d
e
1