Use and Care Manual

10
Care and Cleaning
□ To prolong the original appearance, clean with water and soft, damp cloth only.
□ Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not be covered by the warranty.
□ Do not spray with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on.
□ The light switch is turned off.
□ The fuse is blown or the circuit breaker is
turned off.
□ Daylight deactivation (photocell) is in
effect.
□ The circuit wiring is incorrect, if this is a
new installation.
□ The motion sensor is aimed in the wrong
direction.
□ Turn the light switch on.
□ Replace the fuse or turn
the circuit breaker on.
□ Recheck after dark.
□ Verify the wiring is
correct.
□ Re-aim the motion sensor
to cover the desired area.
The light comes on during
the day.
□ The motion sensor may be installed in a
relatively dark location.
□ Dusk Learn was set at day condition.
□ The light fixture is
operating normally under
these circumstances.
□ Reset the dusk learn
button by pushing once
at the desired level of
darkness, or put back
in the factory setting by
pushing the dusk learn
button twice within 5
seconds.
The light comes on for no
apparent reason.
□ The motion sensor may be sensing small
animals or automobile traffic.
□ The HI-LO switch is set to Dusk-to-Dawn or
Dusk Timer mode.
□ Re-aim the motion sensor.
□ The light fixture is
operating normally under
these circumstances.
The lights turn off too late
in Dusk-to-Dawn setting.
The light fixture may be installed in a relatively
dark location.
Reset the light level (LUX) at
which the sensor operates with
the dusk learn button. This will
allow you to reset the outside
light level at which the motion
sensor becomes active and the
HI-LO feature operates.
161222-IQA-US-RS-2701-FA-ENG(REV17).indd 10 22-Dec-16 8:55:17 AM