Use and Care Manual

7 HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
4
Testing and Adjusting the Motion Sensor
NOTE: The motion sensor will need to completely warm
up (90 seconds) before beginning the setup process.
□ Turn on power and allow the motion sensor to warm
up for about 90 seconds.
The sensor will be in TEST mode automatically
after warm-up until it no longer detects motion
for more than 2 minutes. Lights will come on for
approximately 2-3 seconds in TEST mode.
□ Perform a “walk test” to adjust the sensor coverage
area. Walk in an arc across the front of the motion
sensor (A).
□ Watch the light. The light will come on indicating
motion has been detected.
□ Stop, wait for the light to turn off, and then begin
walking again.
□ Continue this process until the detection zone has
been established.
□ Adjust the sensor up, down, or side to side to change
the motion sensor (A) detection zone to your desired
coverage area.
□ The sensor will automatically switch from Test mode
to Auto sensing mode, after it no longer detects
motion for more than 2 minutes.
A
270°
Operation (continued)
3
Sensor Arm Adjustment
□ If you are using bulbs or fixtures that interfere with
the coverage of your 270° motion sensor coverage,
you can extend the arm of the sensor lower, so it
will be below most bulbs and fixtures.
□ If you are using another type of bulb or
fixture that does not require the extended
arm, you can retract the arm for a more
compact look.
161222-IQA-US-RS-2701-FA-ENG(REV17).indd 7 22-Dec-16 8:55:16 AM