Instructions / Assembly
10
Operating in ARM Mode (continued)
ADJUSTING THE ALARM DURATION
Step Procedure Example
1 Ensure you are in STANDBY mode by entering
the default PIN of 1 2 3 4 OR your new 4-digit
PIN and pressing the Enter button.
The Smart Panel displays this image when in STANDY mode. One beep
indicates that you entered a valid PIN. Three beeps indicate that an invalid
operation was performed.
2 Enter the default PIN of 1 2 3 4 OR your new
4-digit PIN of your choosing. Press the Enter
button.
The Smart Panel displays this image:
3
Press and (as many times as
required) to set the new Alarm Duration.
When is pressed the rst time, the Smart Panel ashes with
the number of minutes currently set for the Alarm Duration. The factory
default setting is 1 minute. Each time this button is pressed, the alarm
duration is increased by a further minute up to the maximum of 6
minutes. The Alarm Duration time on the LCD display will ash until the
setting is completed.
4 Press the Enter button to conrm the setting
and return the Smart Panel to STANDBY.
MUTING THE AUDIBLE COUNTDOWN
When the Smart Panel is ARMED, the audible countdown (beeper) can be silenced by pressing the MUTE button during the countdown. To
reactivate the audible countdown (beeper) press the MUTE button again.
ARMING THE SYSTEM
On the Key Fob Remote Control: Press to ARM the system.
On the Smart Panel: First make sure the Smart Panel is in STANDBY mode, and then ARM the system by completing these steps:
Step Procedure Example
1 Ensure you are in STANDBY mode by entering
the default PIN of 1 2 3 4 OR your new 4-digit
PIN and pressing the Enter button.
The Smart Panel displays this image when in STANDY mode. One beep
indicates that you entered a valid PIN. Three beeps indicate that an invalid
operation was performed.
2 Enter your 4-digit PIN, press the Enter button,
and press for ARM mode.
There is a 20 second exit delay time with a visual and audible (beeping)
countdown before the system is armed. Press MUTE to disable the beeping
countdown. Press MUTE again to resume the beeping.
If the Zone is enabled, a number appears as displayed:
The system will then enter ARM mode after 20 seconds.