Instructions / Assembly
11 HOMEDEPOT.COM
Please contact 844-212-0200 for further assistance.
Operating in ARM Mode (continued)
When in ARM mode, the Smart Panel ashes RED every 5 seconds, acting as a deterrent to potential intruders. However, if an intruder is
detected the panel continuously and rapidly ashes RED.
Once an intrusion has occurred (with the zone triggered under ARM status), the alarm siren sounds and the Smart Panel ashes RED every
1.5 seconds and indicates the triggered zone. After the initial triggering, the alarm will immediately sound, without delay, if any other
sensors are triggered.
DISARMING THE SYSTEM
On the Smart Phone Panel: Enter your 4-digit PIN and press Enter to disarm the system.
On the Key Fob Remote Control: Press to disarm the system.
ZONE SETTINGS
Step Procedure Example
1 Ensure you are in STANDBY mode by entering the
default PIN of 1 2 3 4 OR your new 4-digit PIN and
pressing the Enter button.
The Smart Panel displays this image when in STANDY mode. One beep
indicates that you entered a valid PIN. Three beeps indicate that an
invalid operation was performed.
2 Enter the default PIN of 1 2 3 4 OR your new 4-digit
PIN. Press the Enter button.
The Smart Panel displays this image:
3
Press and to set the ARM mode.
Toggle 1 2 3 4 5 6 7 8 to turn each zone ON or OFF. If no number
appears, the zone is turned OFF. The Smart Panel displays this image:
4 Press the Enter button to conrm the setting and
return the Smart Panel to STANDBY.
TRIGGERS IN ARM MODE
Example: Zone 1 Trigger
Step Procedure Example
1 Under ARM mode Smart Panel displays this image:
2 System Trigger One beep indicates the system is triggered.