Instructions / Assembly

14
Operating in Home Mode
There are default settings that allow the system to operate after opening the package. These settings can be adjusted to suit your individual
requirements. The HOME mode ( ) allows the system to operate in both ARM and ALERT modes in different zones.
HOME mode default setting:
Sensor Zone Status (MODE)
Door/Window Sensor 1 ALERT
Door/Window Sensor 2 ALERT
Motion Sensor 8 ARM
ENTERING HOME MODE
On the Key Fob Remote Control: Press to activate.
On the Smart Panel: Ensure the Smart Panel is in STANDBY mode, and then enter HOME mode by completing these steps:
Step Procedure Example
1 Ensure you are in STANDBY mode by entering the
default PIN of 1 2 3 4 OR your new 4-digit PIN and
pressing the Enter button.
The Smart Panel displays this image when in STANDY mode.
One beep indicates that you entered a valid PIN. Three beeps
indicate that an invalid operation was performed.
2
Enter your 4-digit PIN, press Enter, and to enter
HOME mode.
If the Zone is enabled, a number appears as displayed here:
EXITING HOME MODE
On the Smart Phone Panel: Enter your 4-digit PIN followed by the Enter button to exit HOME mode.
On the Key Fob Remote Control: Press to exit HOME mode.
ZONE SETTINGS
Programming each zone in HOME mode:
Step Procedure Example
1 Ensure you are in STANDBY mode by entering the
default PIN of 1 2 3 4 OR your new 4-digit PIN and
pressing the Enter button.
The Smart Panel displays this image when in STANDY mode. One
beep indicates that you entered a valid PIN. Three beeps indicate
that an invalid operation was performed.
2 Enter the 4-digit PIN followed by the Enter button. The Smart Panel displays this image: