Instructions / Assembly

15 HOMEDEPOT.COM
Please contact 844-212-0200 for further assistance.
Operating in Home Mode (continued)
3
Press and to enter HOME mode.
Toggle 1 2 3 4 5 6 7 8 to turn each zone in different mode:
indicates ALERT mode for a zone
indicates ARM mode for a zone
indicates the zone is turned OFF and the number will not appear
The Smart Panel displays this image:
4 Press the Enter button to conrm the setting and
return the Smart Panel to STANDBY.
Installing the Sensors
This package includes 3 wireless sensors which have a pre-programmed default setting that begins working immediately once the battery
is activated (the Key Fob Remote Control needs to be enrolled onto the system before it can operate). It is advisable to install the main
package rst and then personalize the settings once the system is functioning properly. This section should help you to change the system
settings in order to create a more personal home environment.
First, determine the location of the sensors. Place the sensors where they are not easily accessible, in the most vulnerable rooms or near
key entry points, away from extreme temperature sources (radiators, ovens, stoves etc.) and large metal objects that could interfere with
the wireless performance, and where better RF performance can be achieved (if necessary).
Once you have selected a location for the sensors, the system can be powered up.
INSTALLING THE DOOR/WINDOW SENSOR
The Door/Window Sensor consists of two parts, a transmitter and a magnet. Once this sensor is installed, and the two parts are fastened
onto the door or window, the sensor will trigger and transmit a message to the Smart Panel when the door or window is opened. One Door/
Window Sensor is pre-programmed in Zone 1 and the other one is set in Zone 2. However, these settings can be adjusted according to your
requirements.
Step 1: Powering up the Door/Window Sensor
Remove the battery cover; insert new batteries noting the polarity as shown in the diagram below and
replace the cover. This sensor requires 2 x AAA batteries.
Low battery indication: If the batteries need to be replaced, the RED LED on the transmitter will ash
slowly.
Step 2: Installing the Door/Window Sensor
□ Mount the transmitter on a xed surface such as a door or a window frame.
□ Mount the magnet on a movable surface such as a door or a window.
□ Ensure the >/< marks on the sides of the transmitter and magnet match up as shown in the diagram.
The transmitter and the magnet must be no more than 5 mm (0.2 in.) apart.
Step 3: Mounting with the Double-sided Adhesive Pad
□ Ensure the mounting surface is clean.
□ Peel back one layer of the protective lm and attach it to the transmitter.
□ Peel back the remaining layer of protective lm and press the transmitter rmly in place against the mounting surface until rmly attached.
□ Repeat to attach the magnet.