Instructions / Assembly
19 HOMEDEPOT.COM
Please contact 844-212-0200 for further assistance.
Using the Key Fob Remote Control (continued)
QUERYING THE ID NUMBER OF A REMOTE CONTROL
The ID number of a Remote Control device can be identied as follows:
Step Procedure Example
1 Ensure you are in STANDBY mode by entering the
default PIN of 1 2 3 4 OR your new 4-digit PIN and
pressing the Enter button.
TThe Smart Panel displays this image when in STANDY mode. One
beep indicates that you entered a valid PIN. Three beeps indicate
that an invalid operation was performed.
2 Enter the 4-digit PIN followed by pressing the Enter
button.
The Smart Panel displays this image:
3
Press and to go into Remote Querying
mode, and then press any key on the remote to
check its ID.
After entering into Remote Querying mode, the LCD display will
ash the total number of remote controls currently enrolled to the
system. For example, if 3 remotes are enrolled, the LCD display will
ash “03”.
The ID number of the Remote can then be checked by pressing any
key on the remote. For example, if the LCD display ashes “02”
then that is the ID of the remote.
4 Press the Enter button to complete the query and
return the Smart Panel to STANDBY mode.
Home Security Code Settings
In most cases the factory settings of the House Security Code will NOT need to be changed. However, if the Smart Panel and Sensors
activate intermittently or do not work at all, this may be due to interference with other systems, which can be avoided by changing the
House Security Code. To change this code, complete these steps with each system module:
1. There are four Jumpers/Dip-switches on each device. To locate these, remove the battery compartment cover.
2. Set the Jumpers as shown below (ON - Push in / OFF - Pull out) to change the House Security Code setting. Make sure the Jumpers on
the Smart Panel and its Sensors exactly match each other AND the Dip-switch setting on the Key Fob Remote Control.
Jumpers for House Security Code Smart Panel
- Each sensor
Default House Security Code:
1: ON, 2: ON, 3: ON, 4: ON
*Jumper: ON = Pushed in, OFF = Pulled out
Dip-switches for House Security Code Key Fob Remote Control
Default House Security:
1: ON, 2: ON, 3: ON, 4: ON