Instructions / Assembly

6
Installation
1
Wall mounting the smart panel and
tamperproof switch
□ First cut out the mounting template for the Smart Panel
along with the area which is marked out for the position of
the tamperproof magnet (see below).
□ Tape the template onto the wall, in the position you wish to
install the Smart Panel.
□ Using a pencil, mark on the wall the points for drilling holes
for the wall plugs and mounting screws, and the position
for mounting the tamperproof magnet.
□ Drill the holes, insert wall plugs and locate the mounting
screws for the Smart Panel.
□ Ensure the mounting surface for the tamperproof magnet
is clean.
□ Peel back one layer of the protective lm on the double-
sided adhesive strip and attach it to the magnet.
□ Peel back the remaining layer of protective lm and press
the magnet rmly in the marked position against the
mounting surface until rmly attached.
□ Mount the Smart Panel onto the wall.
□ Once the Smart Panel is installed, power up the system.
The tamperproof system is enabled once the Smart Panel
is switched to HOME, ALERT or ARM mode.
2
Powering up the Smart Panel
controller
NOTE: The Smart Panel is supplied with a demonstration
switch to show the LCD display panel working while the unit
is in its packaging. Before powering up the Smart Panel,
remove the wire for this switch as described below.
NOTE: The main power supply (with AC adaptor) must be
plugged in at all times, with the 9V battery functioning as a
back-up power supply only, when the main power supply is
interrupted.
□ Unscrew the battery compartment and remove the cover.
□ Remove and discard the LED demo socket, if tted.
□ Insert a new back-up battery (noting the polarity) and
plug the AC adaptor into the Smart Panel. One beep
will sound and the backlight will blink within 1 second
(Yellow—Red—Green—Yellow). The Smart Panel will
display this image:
□ The Smart Panel enters STANDBY mode after the automatic
self-checking completes.
□ When the key symbol appears on the LDC screen,
enter 1 2 3 4 (default 4-digit PIN).
□ Replace the cover and screw, and connect the AC adaptor
to a wall socket.
84mm
43mm
16mm
36mm
..
A r e a f o r p o s i t i o n i n g
t a m p e r p r o o f m a g n e t
Mount tamperproof magnet here
Fig. 1 Fig. 2
Fig. 4Fig. 3