Instructions / Assembly

8
Using the Panic Alarm
Pressing the and buttons at the same time on either the keypad or the key remote control will immediately transmit an alarm
signal to the Smart Panel, activating the siren, and transmitting an alarm signal to any optional response devices (Auto Dialer, Outdoor Bell
Box & GSM Device), to request emergency assistance.
To disarm the Panic alarm:
□ On the Smart Panel: Enter your 4-digit PIN followed by the Enter button to exit from the Panic alarm.
□ On the Key Fob Remote Control: Press to exit from the Panic alarm.
USING THE PANIC ALARM WITHOUT ACTIVATING THE SIREN
If you are forced to disarm the system, enter the Duress Password to stop the siren from sounding. The Smart Panel will then silently
transmit an alarm signal to the optional response devices (Auto Dialer, Outdoor Bell Box & GSM Device) to request emergency assistance.
Duress Password:
□ Enter the default 4-digit PIN 1 2 3 4, followed by 1 and Enter, or
□ Enter your personalized 4-digit PIN, followed by 1 and Enter.
Operating in Standby Mode
If in STANDBY mode, the Smart Panel is prepared for mode selection. You must be in STANDBY mode before turning to ARM mode. To ensure
you are in STANDBY mode:
□ Enter the default PIN of 1 2 3 4 or your new 4-digit PIN and press the Enter button. The Smart Panel displays this image when in
STANDY mode. One beep indicates that you entered a valid PIN, three beeps indicate that an invalid operation was performed.
Operating in ARM Mode
When in ARM mode ( ), the Smart Panel siren sounds and the Smart Panel ashes RED every 1.5 seconds when the system is
triggered.
ARM Mode Default Setting
Sensor Zone Status (MODE)
Door/Window Sensor 1 ARM
Door/Window Sensor 2 ARM
Motion Sensor 8 ARM