Use and Care Guide

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Note
：
This equipment has been tested and found to comply with tiie limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against hannful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee tiiat interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct tiie interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between tiie equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which tiie receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device contains licence-exempt transmitter(s)/receiver(s) that comply witii Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may nut cause interference.
2. This device must accept any interference, including interference Wat may cause undesired operation of the device.
RF Exposure
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Illis device should be installed and operated witti minimum
distance 20cm between the radiator and your body.
Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set fortti for an uncontrolled environment This equipment should be installed and operated witti minimum
distance 20cm between the radiator and your body.
CAN ICES-3(B)/NMB-3(B)
FCC RESPONSIBLE PARTY
Globe Electric
2264 East 6th Street
San Bernardino, CA 92410
www.globe-electric.com
11 HOMEDEPOT.CA/HUBSPACE
Please contact 1-877-592-5233 for further assistance.