Use and Care Guide

n Using the function button on the
doorbell
□ Learn a new push button - press and hold the function
button (4) for 3 seconds (the doorbell will sound
“beep-be叩”).
□ See the
Tivubleshooting
section to sync the
push button (B) and doorbell (A).
□ Remove all known push buttons - press and hold the
function button (4) for 10 seconds (the doorbell will
sound “beep-beep-beep").
□ WiFi reset - press and hold the function button (4) and
volume UP button (5) for 5 seconds (the doorbell will
sound
H
beep-be 叩-beep”).
Operation (continued)
7
Muting the doorbell
8
Scheduling a mute event
NOTE: Manually muting or unmuting ttie doorbell will L3
override any scheduled muting event
NOTE: If the doorbell is muted and access to the app to nA
unmirte it is not possible, tiie doorbell can be unmuted by pressing
either of the volume buttons on the side of the doorbell.
nA NOTE: Hie doorbell muting can also be adjusted on tiie home screen
using the speaker icon on the doorbell icon.
The doorbell can be muted manually or for a scheduled
period of time within ttie app. The speaker icon will
change depending on the selected mute function.
口 Mute - The doorbell will be muted until it is
cancelled.
口 Mute for 2 hours - The doorbell will be muted for 2
hours.
口 Mute until sunrise - The doorbell will be muted until
the next morning.
口 Using the app - Select the doorbell in the 叩p. 口
Follow the on-screen instructions to s飢 the start and
end times for muting.
The doorbell (A) can be scheduled to mute at specific
times throughout the day or week.
9
Adding a push button
NOTE
：
This doortell is designed to work with upto 16
wireless push buttons (sold separately).
□ Using the app - Select the doorbell in the app.
□ Select the “Add Button” button.
□ Follow the on-screen instructions.
[Q
Removing
a push button
□ Using ttie app - Select the doorbell and the
desired push button in the app.
□ Select the trash can icon at the top of the screen
and follow the on-screen instructions to remove
the selected push button.
rA NOTE: me Hubspace setup mode is only needed if the QR code is not
available for scanning.
—
3
S
-
O
B