Operation Manual

10 3
It is our pleasure to offer assistance if you have any questions
regarding your Mythos loudspeakers or their set-up. Please contact
your nearest Definitive Technology dealer or contact us directly at
410-363-7148 or www.definitivetech.com.
Service and warranty work on your Definitive loudspeakers will
normally be performed by the Definitive Technology dealer from
whom you have purchased your loudspeakers. If, however, you wish
to return the speaker to us, please contact us first, describing the prob-
lem and requesting authorization as well as the location of the nearest
factory service center.
Please note that the address given in this
booklet is the address of our offices only. Under no circumstances
should loudspeakers be shipped to our offices or returned without
contacting us first and obtaining return authorization.
Definitive Technology Offices
11433 Cronridge Drive
Owings Mills, Maryland 21117
Phone: [phone]
Service
Visit us at www.definitivetech.com
Unpacking Your Mythos Loudspeakers
Base Installation Instructions
Please Inspect For Shipping Damage
Each loudspeaker leaves our plant in perfect condition. Any visible or
concealed damage most likely occurred in handling after it left our plant
and should be reported at once to your Definitive dealer or the delivery
company that delivered your loudspeaker. Please unpack your system
carefully. Save all cartons and packing materials in case you move or
need to ship your system. Record the serial number found on the back of
the Mythos loudspeakers in the appropriate place on your warranty card.
Tools required: 4mm (or 5/32") Allen Wrench
(also called Hex Key driver) (not supplied)
Parts required: Tempered Glass Base (supplied), four Allen head bolts
(supplied), 8 plastic washers (supplied)
Instructions:
1. Carefully lay the Mythos on its side. Lift the base of the speaker about
six inches and support it with a soft padded object, such as a pillow.
Do NOT support the speaker with a hard object, as you might dent or
scratch the aluminum finish.
2. Place one plastic washer on each bolt.
3. Insert the bolts into the glass base from the same side that the silver
feet are attached to.
4. Place another plastic washer on each bolt so the washer is against
the glass.
5. Finger tighten all four bolts into the threaded holes on the bottom of
the Mythos. If this has been done correctly, washers will be between
the metal surface of the Mythos, the glass, and the heads of the bolts.
6. GENTLY tighten each bolt with the Allen head wrench. Do NOT
overtighten or you may crack the glass.
7. Note the label showing the height adjustment ring and locking collar
on the silver feet. Carefully return the speaker to the upright position
and adjust the feet to level the speaker.
Technical Assistance