Owner`s manual

The Deﬁnitive Technology ProCinema 60 System consists of six speakers:

four ProMonitor

60s, one ProCenter

60 and one ProSub

60. Normally two of the

ProMonitor 60s will be used as front speakers and two will be used as side or rear

surround speakers. These speakers can be used with any surround decoding technol-

ogy; however, since they will most often be used with Dolby Digital

receivers and

decoders, the instruction manual is written for Dolby Digital hook-ups (and DTS

which is hooked up the same way). If you are using an earlier ProLogic

receiver,

please contact Deﬁnitive customer service for speciﬁc instructions that apply to

your system.

ProCinema 60 Six-Piece Surround Sound System

Connecting Your Loudspeakers

Usually if distortion is heard when the speakers are being driven at loud

levels, it is caused by driving (turning up) the ampliﬁer too loud and not

driving the speakers with more power than they can handle. Remember,

most ampliﬁers put out their full rated power well before the volume control

is turned all the way up! If your speakers distort when you play them loud,

turn down the ampliﬁer or get a bigger one.

Wiring up Your Speakers to Your Home Theater Surround Receiver

There are many different ways to wire your ProCinema 60 System to your home

theater surround receiver. In order to simplify this process, we will describe the two

most common methods. Method 1, which involves wiring your front left and right

ProMonitor 60s to your ProSub 60 and then wiring your ProSub 60 to your receiver, is

the preferred method in terms of sound quality — it will give you the best blending

between the satellite speakers and the sub as well as the fullest, richest sound quality.

Method 2, which involves wiring the front left and right ProMonitor 60s directly to

your receiver and hooking your sub up with an RCA cable, uses less speaker wire and

still sounds good but clearly not as good as Method 1. We recommend Method 1, if

possible.

Method 1

1) First, wire the + (red) terminal of the left channel speaker wire output of your

receiver or ampliﬁer to the + (red) terminal of the left channel speaker wire

(high level) input of your ProSub.

2) Next, wire the – (black) terminal of the left channel speaker wire output of your

receiver or ampliﬁer to the - (black) terminal of the left channel speaker wire

(high level) input of the ProSub.

3) Repeat Steps 1 and 2 for the right channel.

4) Wire the + (red) terminal of the left ProMonitor 60 to the left channel + (red)

speaker wire (high level) out on the back of the ProSub.

5) Wire the – (black) terminal of the left ProMonitor 60 to the left channel – (black)

speaker wire (high level) out on the back of the ProSub.

* Registered trademarks.