Owner's Manual
Table Of Contents
the center
of
the Mythos Six speaker tenninals will be
3'/4
inches (82 mm)
below the bottom edge
of
the bracket.
To install the Mythos Six on its bracket, securely fasten the two mount-
ing screws supplied into the two threaded holes on the rear
of
the speaker,
screwing them in as far as they will go. The speaker will then hang in the
two "keyholes" on the bracket. After placing the screws in these open-
ings, pressing down finnly on the top
of
the speaker will seat the speaker
properly and avoid any rattles during use.
Using Your
Mythos
Six on a Shelf
or
Furniture
Your Mythos Six comes with an optional tempered glass base for
standing the speaker on a horizontal shelfor on furniture. (For horizontal
installations, the Mythos Seven speaker should be used instead.) For
safety, please make sure the location where you place the speaker is flat
and level. The base must be installed with the included plastic spacer's
smooth silver side against the glass on the surface opposite the feet.
Please make sure that the plastic washers are used with the four supplied
mounting screws.
Do
not over-tighten the mounting screws.
Mounting
Your
Mythos
Seven
with
the
Supplied
Wall-Mount
Bracket
Your Mythos Seven comes with an optional wall-bracket designed to
securely mount your speaker flush to your wall. The bracket can ONLY
be used with a horizontal installation. (For vertical installations, the
Mythos Six speaker should be used instead.) For safety, it is extremely
important that this bracket be installed with molly-bolts or similarly
effective fasteners appropriate for the construction
of
your wall. Be sure
to use all six
of
the mounting holes when fastening the bracket to the
wall. Never use unanchored
or
improperly anchored screws in your wall.
Professional installation is strongly recommended. Your dealer can either
arrange this for you, or refer you to a qualified installer.
To detennine the bracket's position on the wall, the following measure-
ments will be helpful. When the Mythos Seven is installed on the bracket,
the top edge
of
the speaker
is
1 inch (25 mm) from the top edge
of
the
bracket, the bottom edge
of
the speaker
is
1
1
/4
inches (32 nun) from the
bottom
of
the bracket. The right outer edge
of
the speaker is 3
1
/2
inches
(89 mm) from the sides
of
the bracket. The left outer edge
of
the speaker
is 5 inches (129 mm) from the sides
of
the bracket. The center
of
the
Mythos 7 speaker tenninals will be 1
1
/2
inch (37 mm) from the sides
of
the
bracket.
If
you are mounting your Mythos Seven below your display