Use and Care Manual

DEFT WOOD TOUCH-UP/REPAIR/RESTORATION COLORLESS WOOD COATING
WHERE TO USE: This aerosol has the advantages of spray application, great flow, and is
convenient for hard-to-brush areas without the expense and laborious clean-up of spray
equipment.
COVERAGE: 60 square feet per can.
SURFACE PREPARATION: Clean surface thoroughly, sand with fine 220 sandpaper. Remove all
dust with rags soaked in acetone. Test in a small area. If previous finish wrinkles or lifts, strip to
bare wood.
APPLICATION: Cover nearby surfaces, provide adequate ventilation, eliminate ignition sources,
and wear safety glasses. Shake the can for 1 minute. Spray 6-10 inches from surface. Apply thin
coats and recoat in 30 minutes. Recoat 3 or more times. After each use, clear valve by holding
can upside down and spraying until only clear gas comes out. If spray button becomes clogged,
wear eye protection, wipe off the button opening with acetone-DO NOT stick pin in spray
button opening.
CLEANUP: Use acetone for clean-up.
DISPOSAL: Contact your local environmental regulatory agency for guidance on disposal of
empty can. Do not burn or place in home trash compactor.
NOT RECOMMENDED FOR EXTERIOR USE.
PRECAUTIONS AND FIRST AID: Sanding and grinding dusts may be harmful if inhaled. In a fire
or if heated, a pressure
increase will occur and the container may burst or explode. This material increases the risk of
fire and may aid combustion. Keep away from heat, sparks and flame. Keep away from flames,
such as a pilot light, and any object that sparks, such as an electric motor. Do not puncture or
incinerate container. Do not expose to heat or store at temperatures above 120°F. Keep away
from combustible material. Do not breathe vapor or mist. Do not swallow. Do not get on skin or
clothing. Avoid contact with eyes. Keep container tightly closed and sealed until ready for use.
Wash thoroughly after handling. Provide fresh air ventilation during and after application and
drying. Avoid the inhalation of dust, particulates, spray or mist arising from the application of
this preparation. Use personal protective equipment as required. DANGER–RAGS, STEEL WOOL
OR WASTE SOAKED WITH DEFT WOOD TOUCH-UP/ REPAIR/RESTORATION MAY
SPONTANEOUSLY CATCH FIRE IF IMPROPERLY DISCARDED. IMMEDIATELY AFTER EACH USE,
PLACE RAGS, STEEL WOOL OR WASTE IN A SEALED WATER-FILLED METAL CONTAINER. FIRST
AID: If swallowed, rinse mouth with water (only if the person is conscious). Call physician
immediately. Do not induce vomiting unless directed to do so by medical personnel. If in eyes,
rinse with water for 15 minutes. Check for and remove any contact lenses. In case of contact,

Summary of content (2 pages)