Service manual

2-8 Sun StorEdge D240 Media Tray Installation, Operation, and Service Manual • August 2001

FIGURE 2-8 Attaching the Mounting Ear to the Media Tray

4. Using a torque-measuring wrench or screwdriver, tighten the flathead screws

through the top and bottom aligned holes to secure each mounting ear to the

media tray front sides.

Tighten all screws to 3.3–4.1 N-m (29–36 in-lbs).

5. Attach the mounting rails.

a. Partially install the top panhead screws in the rack holes on both the left and

right sides of the rack. Do not fully tighten the screws.

The key holes on the rails install in holes one position above the top mounting ear

screw. For example, if you attach the top ear screw at hole 100, you must install

the screws for the key holes at hole 101.

Note – If you are installing the mounting rails in the Sun Enterprise system cabinet,

the key hole in the recessed flange attaches towards the rear of the cabinet, as shown

in FIGURE 2-9 A.