Service manual

Chapter 2 Installation 2-9
Note – If you are installing the mounting rails in the Sun StorEdge expansion
cabinet, the key hole located past the recessed flange attaches towards the rear of the
cabinet, as shown in FIGURE 2-9 B.
FIGURE 2-9 Mounting Rail Rear Holes for Sun Enterprise (A) and Sun StorEdge (B)
Cabinet Racks
6. Holding each mounting rail, slide the rear key hole past the rear screw head.
a. Slide the front key hole past the front screw head.
b. Lower the rail so that the key holes on both mounting rails seat with the screws
in the rack.
7. Attach the bottom panhead screws on the rails (two screws per rail).
8. Using a torque-measuring wrench or screwdriver, tighten all screws to 3.3–4.1 N-m
(29–36 in-lbs) to hold the rails securely to the rack.
A
B
Rear screw
locations for
the media tray