Service manual

Chapter 4 Service 4-13
d. Pull the bracket handle out and swing it open until it pushes against the
chassis.
e. Continue pushing the handle against the chassis, applying mild pressure until
the drive pops out from the connector.
f. Slide the drive out and place it on an antistatic mat.
g. With the bracket extended, insert the replacement disk drive into the drive bay,
aligning the connector on the drive with the connector on the backplane.
h. Slowly and gently push the drive in until the metal drive handle contacts the
enclosure metal rib.
Note – Be sure you insert the drive in the correct drive bay to mate with the
connector on the backplane.
i. Swing the drive bracket handle closed until it latches.
j. Remove the wrist strap.
k. Replace the front bezel on the media tray.
3. Restore the Solstice DiskSuite diskset files.
Use the following procedure to configure a slice on a disk to be used with the
Solstice DiskSuite software.
a. Restore the disk partitioning.
■ If you have saved the disk partitioning to a file, you can restore it with fmthard.
For example:
■ If you have not saved the disk partitioning, use the format(1M) or fmthard(1M)
commands to repartition the disk.
b. Replace any database replicas.
For example:
# fmthard -s /etc/c1t4d0s0.vtoc /dev/rdsk/c1t4d0s0
# metadb -a -1 2000 -c 2 c1t4d0s0