Service manual

4-18 Sun StorEdge D240 Media Tray Installation, Operation, and Service Manual • August 2001
FIGURE 4-5 Installing a Power Supply
1. Holding the handle, push the replacement power supply firmly into the chassis.
The power supply connector slides into the chassis and mates smoothly with the
main logic board connector. Physical damage to the power supply connector can
result from the application of excessive force.
2. Rotate the handle upward 90 degrees and seat the power supply to the main logic
board.
3. Latch the handle under the purple snap catch.
4. Tighten the two captive screws on the power supply.
5. Reconnect the power cord.
PS1
PSØ