Operation Manual

Page 7
To set power save mode
Power save mode switches the display off until required. Then the display will function normally
but if no buttons are pressed within a 10 second period, the display will clear.
To activate power save, proceed as follows:
1. Press and hold the less button for 3 seconds.
The oven beeps and the display will clear.
2. To cancel power save , press the clock but-
ton and thereafter hold the less button for 3
seconds. The display will re-appears and the
oven beeps.
Operational notes to remember
1. While learning to operate the oven, place a cup
of water on the tray inside the oven. This will
absorb any microwave energy generated while
you experiment. Never switch the oven on when
it is empty.
2. At the end of a cooking cycle, the oven beeps 3
times, OPEN DOOR is displayed, the oven light
switches off and the tray stops rotating.
3. The oven will beep every 10 minutes thereafter
unless the stop/clear button is pressed.
4. If the cooking period exceeded 5 minutes, the cool-
ing fan will continue to function for approximately
5 minutes after the cooking has stopped and
COOLING is displayed.
5. Opening the door will interrupt any operation ex-
cept the cooling fan.
6. If the door is inadvertently left open for 10 minutes
or longer, a beep will sound every 10 minutes until
the door is shut again.
7. To interrupt any operation, press the stop/clear
button. To resume the operation, press the start/
speedy cook button.
8. To cancel any operation , press the stop/ clear but-
ton twice.
9. For cooking periods of up to 5 minutes, the time
set will be in 10 second increments.
10. For cooking periods of up to 10 minutes the time
set will be in 30 second increments.
11. For cooking periods of up to 60 minutes the time
set will be in 1 minute increments.
12. The oven light will only switch on when the oven
is operating.
Safety tip.
At the end of the cooking cycle.
Opening the door.
Interrupting any operation.
Cancelling any operation.
Time setting.
Oven light.