OWNER’S MANUAL MODEL 501 SOLID PLATE PLUG IN STOVE MODEL 520 SPIRAL PLATE STOVE Available in White only PART NUMBER 068 517 www.defy.co.
Introduction Congratulations on the purchase of this quality appliance. We trust that you will enjoy many years of trouble free use. Please read these instructions carefully before using the appliance. This manual will provide you with information on how to operate and care for your appliance in order that you gain the maximum benefit from it. Unpacking • Please ensure that packaging material is disposed of in a responsible manner.
Anti-tilt mechanism Method 1 All stoves can tilt if you or a child sit or lean on an open oven door. Safety regulations stipulate that the ANTI-TILT mechanism supplied with the stove, must be fitted as shown in methods 1 or method 2, depending on the mechanism supplied with your particular model. The Anti-tilt bracket kit assembly comprises of: A B C D • • • • • • • • • • • 2 x Anti-tilt brackets (stove). 2 x Anti-tilt brackets (wall). 6 x Securing bolts (4 short and 2 long). 4 x Hilti fasteners.
Anti-tilt mechanism Method 1 C C B A A Wall B Stove D Parts Anti-tilt installation side view C Stove C B A Wall A A C B B Assembly Anti-tilt installation top view The manufacturer strives for continuous improvement. For this reason, technical specifications, text and illustrations in this manual are subject to change without notice. Figures in this manual are schematic and may not match your appliance exactly.
Anti-Tilt mechanism Method 2 • • • • • • • • • • “A” 1 x Stability chain “B” 1 x Stability hook with anchor sleeve “A” is factory fitted at the rear of the stove in the centre. Position the stove and move “A” to touch the wall behind the stove. Mark the hole where “A” touches the wall behind the stove. Move the stove away from the wall to allow for an area to work in. Using a 8.0 mm concrete bit, drill a hole at the marked position.
Oven door (Only applies to models with removable oven door) The oven door may be removed to improve access to the oven for cleaning purposes. 1. Open the door fully to expose the hinges (A) on either side. 2. Flip the hinge locking levers (B) to the upright position. 3. Partially close the oven door and lift it free of the side panel retaining slots. 4.
The Control Panel (501 Model Only) Electrical Installation Position the stove on a solid level surface near an accessible plug point. • The stove is a plug-in model with a 15Amp. Power supply. • Push the electric plug into a 230V. 15A. earthed wall socket. Selector Knob • It is not possible to use all the elements at the same time. • Set the selector to the required position. • Do not set the knob to the unmarked position.
THE CONTROL PANEL OVEN INDICATOR LIGHT OVEN THERMOSTAT PLATES SELECTOR The Control Panel (521 Model only) THE CONTROL PANEL OVEN INDICATOR LIGHT OVEN THERMOSTAT PLATE INDICATOR LIGHTS PLATES SELECTOR Four Position Selector • The selector is used to select one of four oven operating modes. OFF POSITION 0 G RILL B A KE 1. 0 or OFF 2. Bake 3. Pre-Heat 4. Grill • BAKE is used for baking and roasting. • PRE-HEAT utilises all the oven elements to quickly bring the oven up to the selected temperature.
• • Use hot soapy water to clean the plates, supports, trims and under-cups. If necessary use a nylon bristle brush to remove stubborn dirt. Wipe dry and re– fit the plates, supports, trims and under-cups. Solid plates • Before using the plates for the first time, switch them on for four minutes at the highest setting so that the factory applied protective coating can burn in. • The markings around the plate control knobs represent the following heat settings: • 1 = Warming. • 2 = Slow simmer.
Safety advice This section contains safety instructions that will help you avoid risk of injury and damage. All warranties will become void if you do not follow these instructions. General safety • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Defy Service Centres BLOEMFONTEIN 160 Long Street, Hilton, Bloemfontein 9301. Tel. 051 400 3900 Bloemfontein.Service@defy.co.za CAPE TOWN 5A Marconi Rd. Montague Gardens, 7441. Tel. 021 526 3000 CapeTown.Service@defy.co.za DURBAN 35 Intersite Avenue, Umgeni Business Park, Durban 4051. Tel. 031 268 3300 Durban.Service@defy.co.za EAST LONDON 16 Bowls Rd. Arcadia, East London 5201. Tel. 043 743 7100 EastLondon.Service@defy.co.za POLOKWANE 87 Nelson Mandela Drive. Superbia 0699. Tel. 0152 92 1166 / 7 / 8 / 9.
Warranty This certificate is issued by DEFY APPLIANCES (PTY) LIMITED manufacturers of Defy and Ocean products, hereinafter the Company, to the original purchaser only, of the appliance described on the certificate and shall constitute the only warranty given in respect of this appliance.