Brush Cutter User Manual

-47-
143245 - Rotary Cutter 1020/1520 (30-March-2007)
118447 - Lock Nut, 5/8”
UNC GRC -Unitorque
117462 - Flat Washer, 5/8”
501003 - Bumper, 2” x 5/8”
501006 - Rubber Spring
117461 - Bolt, 5/8” x 6” UNC GR8
500730 - Lower Strut
(Strut Only)
117111 - Bushing,
1-1/2” OD x 1”
500400 - Rockshaft
500412 - Pin, 1” x 4-11/16”
118966 - Roll Pin, 5/16” x 1-3/4” (2)
131020 - Flat Washer 1” SAE (2)
243500 - Lock Pin, 5/16” x 2-1/2”
500330 - Bolt, 1-1/4”
x 7-1/2” UNF
(c/w Grease Fitting)
500840 - Transport Lock
131206 - Flat Washer,
1-1/4” SAE
118962 - Lock Nut,
1-1/4” UNF GR8
Rockshaft Assembly
Rockshaft Suspension Detail
Preloading of rubber spring required
on all strut assemblies. Exposed
thread length should be
approximately 1/2”
when using correct
hardware.
1/2”
118962 - Lock Nut, 1-1/4” UNF GR8
117454 - Bolt,
1-1/4” x 8“
UNF GR8
131206 - Flat Washer, 1-1/4” SAE
118417 - Lock Nut, 3/8” UNC GR5 (2)
118644 - Bolt, 3/8” x 3” UNC GR5 (2)
118336 - Grease
Fitting, 1/4” (1)
500726 - Walking Axle (opposite confi guration)
Walking Axle
Hub & Spindle Assembly (2)
(see detail on page 49)
117082 - Bushing, 83.2mm OD (2)
500729 - Pin, 2-7/8” OD x 5-3/4” (1)
500725 - Walking Axle