Brush Cutter User Manual

-48-
143245 - Rotary Cutter 1020/1520 (30-March-2007)
Wheel Strut Assemblies
118447 - Lock Nut, 5/8” UNC
GRC -Unitorque
117462 - Flat Washer, 5/8”
501003 - Bumper, 2” x 5/8”
501006 - Rubber Spring
117461 - Bolt, 5/8” x 6” UNC GR8
500730 - Lower Strut,
Double Wheel - Common
118417 - Lock Nut, 3/8” UNC GR5 (2)
118644 - Bolt, 3/8” x 3” UNC GR5 (2)
118336 - Grease
Fitting, 1/4” (1)
500726 - Walking Axle - Right Wing (not shown)
500330 - Bolt, 1-1/4”
x 7-1/2” UNF
(c/w Grease Fitting)
131206 - Flat Washer,1-1/4” SAE
118962 - Lock Nut,1-1/4” UNF GR8
118962 - Lock Nut, 1-1/4” UNF GR8 (2)
117454 - Bolt, 1-1/4” x 8“ UNF GR8 (2)
118963 - Flat Washer, 1-1/4IN GR8 (1)
Hub & Spindle Assembly
(see Detail on page 49)
118417 - Lock Nut,
3/8” UNC GR5
118644 - Bolt, 3/8”
x 3” UNC GR5
500735 - Lower Strut,
Single Wheel
Lower Strut
Double Wheel
Suspension Components
500455 - Upper Strut,
- Left Side (Shown)
500450 - Upper Strut,
- Right Side (Not Shown)
Walking Axle
Wing Suspension Detail
Preloading of rubber spring required
on all strut assemblies. Exposed
thread length should be
approximately 3/8”
when using correct
hardware.
3/8”
Hub & Spindle Assembly (2)
(see detail on page 49)
Lower Strut
Single Wheel
117082 - Bushing, 83.2mm OD (2)
500729 - Pin, 2-7/8” OD x 5-3/4” (1)
500725 - Walking Axle - Left Wing
Upper Strut
Common