User's Manual

User guide P.17
 Turn the ignition key to the IGNITION ON (RUN) position.
 Press and hold the button until the parking lights come ON for
2 seconds, pause, and then flash once.
If Safe Start is enabled, you can activate Cold Weather Mode by:
 Pressing and releasing the button, then, pressing and holding
the button until the parking lights flash 3 times.
To verify whether the system is in Cold Weather Mode (automatic transmissions
only):
 Press the brake pedal:
 If the vehicle is in cold weather mode, the parking lights will remain ON
while the brake pedal is pressed.
Extended Run Time
With the vehicle running under a remote start, pressing and holding the
button for more than 3 seconds will reset the run time counter to zero
and restart the run time cycle from the beginning.
 The horn (if programmed) will honk once;
 The parking lights will flash slowly 3 times then remain lit.
To stop the vehicle at any moment, simply press the button. This
procedure can only be carried out once per remote start.
Example: If your Module is programmed for a runtime of 3 minutes and your
vehicle has been running for 2 minutes already, pressing the button
will reset the counter to zero and the Engine will run for another cycle (in this
case, 3 minutes).
Disable/Enable LED flashing
 To disable the LED: Press and simultaneously
until the parking lights flash three times.
 To Enable the LED: Press and simultaneously until the
parking lights flash once.