User's Manual

P.10 User Guide
To set the system to Ready Mode:
If Ready Mode is enabled by remote
If Ready Mode is enabled by
handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear
selector is in the neutral position.
2. With the engine running, apply the
parking brake once and release the
brake pedal.
3. Within 20 sec. of engaging the
parking brake, press and hold ,
or on the transmitter
(SmartStart™ uses only the
SmartStart™ icon).
The parking lights will flash 3 times
quickly and remain lit. Release the
button.
2. With the engine running, apply the
parking brake twice within 10 sec.
3. Make sure to release the brake
pedal.
The parking lights will flash 3 times
quickly and remain lit.
4. Remove the key: the engine will keep on running.
5. Exit the vehicle. All doors should be closed, including the hood and trunk.
6. THERE ARE THREE POSSIBLE OPTIONS TO COMPLETE READY MODE
(programmable by installer)
OPTION 1:
No Lock
OPTION 2:
Manual Shutdown
(default)
OPTION 3:
Automatic
Shutdown
The engine stops.
The engine keeps going until
you press either;
a. to lock the doors and
shut down the engine;
b. to unlock the doors and
shut down the engine;
c. to shut down the engine
without affecting the doors.
The engine runs for
8 sec. then locks the
doors before finally
shutting down the
engine, without user
interaction.
WARNING: The
vehicle is not armed
or locked down.
WARNING: Engine runs until
the pre-programmed run time
expires.
WARNING: Do not
leave your keys in the
vehicle!
7. The Parking lights will flash twice to indicate Ready mode is set.