User Instructions

2211

sseeccoonnddaarryy hhaarrnneessss ((HH22)) wwiirree ccoonnnneeccttiioonn gguuiiddee

This wire sends a negative pulse every time the remote start is activated and the alarm is disarmed. This can be

used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to

the disarm wire as shown in the diagrams below. This wire can also be used as a special accessory output. (See

Feature Descriptions

section of this guide.)

RReellaayy ffoorr NNeeggaattiivvee ((--)) DDiissaarrmm WWiirree RReellaayy ffoorr PPoossiittiivvee ((++)) DDiissaarrmm WWiirree

Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-

board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK wire can be directly

connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must

be used to change the polarity. (See

Finding the Wires You Need

section of this guide.) Here are some common

colors of this wire:

■ Chevrolet and GMC trucks - Light blue or dark blue

■ Ford Trucks - Black/pink

■ Dodge Ram Trucks - Orange/black or black/orange

NNOOTTEE!!

A 1-amp diode must be installed in line on the factory wire between the wait-to-start

indicator and the ECM. (See the following diagram for details.)

HH22//22 GGRRAAYY//BBLLAACCKK ((--)) wwaaiitt ttoo ssttaarrtt iinnppuutt

HH22//11 LLIIGGHHTT GGRREEEENN//BBLLAACCKK ((--)) ffaaccttoorryy ddiissaarrmm oouuttppuutt