User's Manual

1
© 2011 Directed Electronics. All rights reserved.
User’s Guide
6703A Lot Management System Hub
Logo, Directed Electronics w-driven.eps
Logo, Directed with designed in USA.eps
Logo, Directed with Distributed By.eps
Directed Logo Usage
Getting Started
Connect the hub to the designated computer* using the
USB cable provided. The unit is powered via this cable
which is also used for data exchange. Position the hub at
the highest possible point in an area free of obstructions
or interference. Rotate the antenna to the upright position.
The hub is used to relay information between the 7703A
keypad and the computer. When the hub is connected to
power, it initializes by testing each display character in
sequence before providing status feedback. Due to the
display’s limited character capacity, system status is ab-
breviated. These abbreviations are as follows:
Display Description
UN hub is unplugged, verification is off
UN VO hub is unplugged, verification is on
PA PC is active, verification is off
PA VO PC is active, verification is on
NR PC is not responding, verification is off
NR VO PC is not responding, verification is on
*This designated computer uses proprietary pre-loaded
software which enables the hub to transfer data via this
system to a remote database.
FCC/ID Notice
This device complies with Part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for Class B Digital Device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures.
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and
receiver
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected
Antenna
Display
Mini-USB
por t